Pandya Raj

IR3009

The process started with a basic volumetric cuboide, of L 1300, B 800 and H 500 such that the idea was to achive the density by subtracting the mass by which opacity and porocity is achived. So i started with the centre of the volume by creating a planer surface in the X axis and Y axis, and after that the process started with the models where it was like that to use 5 different material in a way which should convey the property of the actual material what we think to use in back of the mind. So the process progressed with the X and Y planer surface in the volume. Then the next step was to repeat the planer surfaces on the X and Y axis to make a dense grid, which leads to the formation of points on Z axis, and that points became the 1st step towards the kit of parts for the developments of the volume. The points transformed into the linear members on Z axis and through that process Only points on X and Y axis were also developed and also the linear member on X and Y axis. SO the linear members became the main kit of parts now it was that to have a rule for using the kit of parts in the volume, The process for the developing kit of parts started with the idea of untouching Axis in which the X,Yand Z axis gets visvually intersecting but not in real, They are some how connected to each other but not actually intersecting eachother, with this further added the rule of ADOL which is the ascendeing and dscending of the linear members. Well this changed the over all design apporoach as all the members in X,Y and Z axis Started having increasing and decreasing sizes of the linear members.